Aiphone GH Series Quick Start Installation Manual page 3

Correcting or changing an ID setting:
In order tocorrect a programming error, the entrance station(s) and the tenant station(s) must be cleared of
their incorrect program data, then programmed again correctly. Follow these steps to clear:
1. Put the system into programming mode using the procedure
described on page 1, step 3.
2. At the tenant station, press and hold the door release button and bell
button simultaneously until a beep is emitted from the unit (should
take about 3 seconds). The internal memory is now cleared.
3. If using the GH-SW, press and hold the call button that you wish to
clear until you hear a continuous beep. If using the GH-NS, display
the resident info on the screen that you wish to clear, then press and
hold the bell button (call button) until you hear a continuous beep.
That address in the entry panel is now cleared. u O'
GH-NS
4. You can now re-program the tenant
station(s) using the procedure on page 1.
Programming multiple entrance stations / Concierge stations via Link Data:
If your system has more than one entrance panel and/or you're using the GH-NS module or GH-MK
Concierge station, you can send all of the tenant ID's you just programmed to the other units using the Link
Data feature. This can be done manually via the keypad on the entry panel or via the supplied software.
Using the keypad
and scroll module:
- ©
- ® / .O ...,
Using the supplied software:
1. Import the data from the GH-NS that
you've set the ID's on into the software
with the LinkData box checked.
2. Export the data you just imported to
each of your other GH-NS modules
with the LinkData box checked.
Note: The GH-I\ be used to manually transfer data to other GH-MK's or GH-NS's in the system.