Aiphone GH Series Quick Start Installation Manual page 15

4=2
4-1
Standard System (1)
[1] Entrance Station
[2] Door release timer (set
• Set the duration for the d<
release button is pressed.
[0.5] - [20]: 0.5 secs - 20 secs
[20] - [M]: Activates while the button is pressed.
[3] Setting switch (GH-DA/A)
• SW2: 1: Setting switch for camera entrance station monitoring
function (set to OFF at time of shipment)
ON (Up): Monitored.
OFF (Down): Skipped at time of entrance station monitoring.
• SW2: 2-4 ....
A When installing multiple entrance stations, make sure to set
the GH-DA/A ID numbers (SW2).
[4] External signaling relay GH-RY
For details, see 4-5.
[5] Door release relay contact
Less than AC/DC 24 V, 4 A (resistance load)
PT: AC Transformer
For connecting the access control keypad module GF-AC,
refer to the GF-AC Installation & Operation Manual.
[6] Security guard station GH-MK
[7] Setting switch (GH-MK)
• SW1: 1: Password reset switch
Set the password reset switch to ON for 2 seconds or more
during standby will reset the password (set to "* 1111" at time
of shipment).
• SW1: 2, 3: Unused switch
• SW1: 4: Security guard station number setting switch (set to #1
at time of shipment)
A When installing two security guard stations, make sure to set
the ID numbers (SW1).
[8] Doorbell button
[9] Power supply PS-2420UL
[10] Video Bus control unit GH-VBC (SW2: STD)
[11] Video Bus control unit GH-VBC (SW2: EXP)
• To use GH-VBC as an extension adaptor, set the setting switch
to "EXP". Connect only "INI" terminal at input side.
[12] Bus control unit GH-BC
[13] Distribution terminal (junction): Not included
NP: Non-polarized
4-2
Standard System (2) Station-to-Station Wiring
[1] Residential station GH-1KD, GH-1AD
• There can be a maximum of 25 stations per trunk.
• For the terminating residential station GH-1KD, set the setting
switch (SW1) to "A".
[2] Short lead
• To use the emergency alarm switch (see 11-7 for details),
disconnect the short lead and connect the switch.
[3] Option Connector
For details, see 4-6.
A The separate option connecter is required.
[4] Doorbell button
A1. Do not mix station-to-station wiring with homerun wiring.
A 2. Station-to-station wiring is not possible for GH-1MD.
NP: Non-polarized