Battery Charger Cradle (Hx Ls); Use; Switching On And Off; Selecting The Suction Power Level - Miele HS19 Operating Instructions Manual

en
Battery charger cradle (HX LS)
(Fig. 31)
(depending on model)
Before charging for the first time, you
must read the information in "Installa-
tion and connection – General battery
information".
When charging the battery for the first
time, you must use the PowerUnit. As of
the second charging operation, you can
use the battery charger cradle instead.
 Push the battery into the charger
cradle until it audibly clicks into place.
 Insert the plug into a power socket.
The charging process will start. The bat-
tery charging state indicator flashes on
the left.
You can find out more about the battery
charging state indicator in "Installation
and connection – Battery charging state
indicator".
If you place the run-down battery in
the charger cradle straight after use, it
will only start charging once the bat-
tery has cooled down.
The cooling process can take up to
60 minutes. The battery charging state
indicator on the charger cradle will not
respond during this time.

Use

Switching on and off (Fig. 32)
 If you have charged the battery in the
wall bracket, take the vacuum cleaner
out of the wall bracket.
 If you have charged the battery dir-
ectly, unplug the charger from the
charging socket on the bottom of the
battery.
80
For the best possible cleaning results,
always activate the ComfortClean
function before switching on the va-
cuum cleaner (see "Maintenance –
Activating the ComfortClean func-
tion").
 Press the On/Off switch on the Com-
fort handle .

Selecting the suction power level

(Fig. 32)
The suction power level can be adjusted
for the specific situation. Reducing the
suction power reduces the amount of
effort required to manoeuvre the Elec-
trobrush.
There are 3 power levels to choose from
on the Comfort handle:
Min. Lowest power level for light
soiling
Eco Medium power level for nor-
mal soiling
Max. Highest power level for
heavy soiling
The floor covering detection function is
activated at every power level.
The Electrobrush power consumption is
automatically set to the optimum level
based on the type of flooring and roller
brush used – this can lead to a change
in the operating noise.

Illuminating the work area

(depending on model)
The Electrobrush on your vacuum
cleaner is equipped with BrilliantLight to
illuminate the work area.