Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Miele SO Series
Summary of Contents for Miele SO Series
- Page 1 Operating instructions Cordless vacuum cleaner en-GB HS19 M.-Nr. 11 829 700...
-
Page 2: Table Of Contents
Contents Warning and Safety instructions..............Safety instructions and warnings for AP01/AP02/AP03 battery, LG01/LG02 charger, LS03 charger cradle (depending on the model) ........Guide to the appliance ..................14 Caring for the environment ................16 Installation and connection ................18 Assembling the vacuum cleaner ................. 18 Using the PowerUnit solo.................. - Page 3 Contents Cleaning the dust container ................38 Cleaning the Electrobrush/handheld brush (depending on model)..... 38 Replacing the rechargeable battery ..............39 Error messages ....................40 Problem solving guide ..................41 Service........................ 43 Contact in case of malfunction ................43 Warranty ......................43 Cleaning and care .....................
-
Page 4: Warning And Safety Instructions
“Installation and connection” section as well as the safety instruc- tions and warnings. Miele cannot be held liable for injury or damage caused by non- compliance with these instructions. Keep these operating instructions in a safe place and pass them on to any future owner. - Page 5 Warning and Safety instructions Correct application This vacuum cleaner is intended for cleaning flooring in domestic households and similar residential environments. This vacuum cleaner is not suitable for use on construction sites. This vacuum cleaner is not intended for outdoor use. ...
- Page 6 Warning and Safety instructions Safety with children Children under 8 years of age must be kept away from the va- cuum cleaner unless they are constantly supervised. Children aged 8 and older may only use the vacuum cleaner without supervision if they have been shown how to use it in a safe manner.
- Page 7 The Miele Multi Floor XXL Electrobrush and the Miele Electro Compact handheld brush (varies according to the model) are addi- tional motor-driven devices designed specially for this Miele vacuum cleaner. For safety reasons, the vacuum cleaner must not be used with a different Miele Electrobrush/handheld brush or an Electro- brush/handheld brush produced by another manufacturer.
- Page 8 Warning and Safety instructions Repairs should only be carried out by a Miele authorised service technician. Repairs and other work by unqualified persons can cause considerable danger to users. Correct use Do not use the vacuum cleaner without the dust container, pre-fil- ter and fine dust filter fitted.
-
Page 9: Safety Instructions And Warnings For Ap01/Ap02/Ap03 Battery, Lg01/Lg02 Charger, Ls03 Charger Cradle (Depending On The Model)
The AP01/AP02/AP03 battery, the LG01/LG02 charger and the LS03 charger cradle are designed for use with the Miele HS19 va- cuum cleaner. For safety reasons, the vacuum cleaner must not be used with a battery, charger or charger cradle produced by another manufacturer. - Page 10 The function and operation of the protective measures provided in the domestic electrical installation and in this Miele product must also be maintained in isolated operation or in operation that is not synchronised with the mains power supply, or these measures must be replaced by equivalent measures in the installation.
- Page 11 The user is permitted to transport the AP01/ AP02/AP03 battery by road without having to observe any further re- quirements. Please contact the Miele Customer Service Department before sending the AP01/AP02/AP03 battery. Only send AP01/AP02/ AP03 batteries that are undamaged and have been fully run down.
- Page 12 Warning and Safety instructions Correct use Do not drop or throw the AP01/AP02/AP03 battery. For safety reasons, do not continue to use an AP01/AP02/AP03 battery which has been damaged. Keep the AP01/AP02/AP03 battery away from naked flames or other heat sources.
- Page 13 The manufacturer cannot otherwise guarantee the safety of the product. Miele can only guarantee the safety of the appliance when genu- ine Miele replacement parts are used. Faulty components must only be replaced with genuine Miele replacement parts.
-
Page 14: Guide To The Appliance
Guide to the appliance... - Page 15 Guide to the appliance a Fine dust filter (HX FSF-2) b Pre-filter c Dust container d Dust container flap e PowerUnit with a connection at the bottom for the battery, a connector at the bottom for the suction tube and Electrobrush, and a connector at the top for the suction tube and Comfort handle f Release buttons for battery (on both sides of the battery) g Charging socket (at the bottom of the battery)
-
Page 16: Caring For The Environment
Miele, free of charge. By law, you are solely responsible for deleting any personal data from the old appliance prior to disposal. You are legally obliged... - Page 17 Caring for the environment Disposing of old batteries In many cases, electrical and electronic appliances contain batteries which must not be disposed of with house- hold waste after use. You are legally ob- liged to remove any old batteries which are not securely enclosed by the appli- ance and take them to a suitable collec- tion point (e.g.
-
Page 18: Installation And Connection
Installation and connection (see “Use – Self-standing function for Assembling the vacuum short pauses in vacuuming”) cleaner - Ergonomic (reduced strain on the You can assemble the vacuum cleaner wrist) in 2 different ways. - Convenient cleaning of large surfaces The advantages of placing the PowerUnit at the top of the vacuum cleaner are as follows: –... -
Page 19: Connecting The Comfort Handle
Installation and connection Connecting the Comfort handle Depending on how you decide to con- figure your vacuum cleaner, you can connect the Comfort handle to either the suction tube or the PowerUnit. Press the release catch and remove the Comfort handle by pulling it up- wards. -
Page 20: Inserting The Battery
Installation and connection Push the PowerUnit connector into the suction tube from above until it audibly clicks into place (right image detail). If you want to separate the sections again, press both release catches at the side of the battery to remove the battery. -
Page 21: General Battery Information
Installation and connection However, if you use the PowerUnit solo and select the minimum power level, you can vacuum for up to 60 minutes at a time. Charging the battery (without wall mounting) You can store the vacuum cleaner up- right and charge the battery directly. Before charging the battery for the first time, you must read the information in “Installation and connection –... -
Page 22: Charging The Battery (With Wall Mounting)
Installation and connection You can read more about this in “Bat- tery charging state indicator (while charging)”. Charging the battery (with wall mounting) There are 2 ways to store and charge the vacuum cleaner in the supplied wall bracket. Before charging the battery for the first time, you must read the information in “Installation and connection”... -
Page 23: Wall Mounting
Installation and connection Wall mounting Attaching the mounting plate The supplied wall bracket has a mount- 2 plugs and 2 T20 TORX screws are ing plate with a bag of screws attached supplied for attaching the mounting to the back. plate to the wall. Attach the mounting plate to the point You will also need a battery-operated on the wall where you want the wall... - Page 24 Installation and connection Connecting the wall bracket Attach the mounting plate to the wall. Slide the wall bracket down into the Connecting the accessories mounting plate from above until it holder (if required) audibly clicks into place. An accessories holder is supplied for storing the 3-piece accessory set on the wall bracket (see “Using the ac- cessories supplied”).
-
Page 25: Battery Charging State Indicator (While Charging)
Installation and connection The charging process will start. If the battery has not been used for a long time and has run down, it will go Battery charging state indic- into safe mode. As a result, the battery ator (while charging) charging state indicator will only re- spond after approximately 30–60 The battery charging state is displayed... -
Page 26: Using The Supplied Accessories
Using the supplied accessories Accessories holder for the Miele offers a range of suitable ac- suction tube cessories for many special applica- tions (see “Optional accessories”). This accessories holder allows you to carry around 2 accessories from the 3- Upholstery nozzle XL piece accessory set while you vacuum. -
Page 27: Multi Floor Xxl Electrobrush
Using the supplied accessories Tip: If you ever need to vacuum up sub- Multi Floor XXL Electrobrush stantial amounts of coarse dirt or Follow the flooring manufacturer’s debris, use the PowerUnit solo (see “In- cleaning and care instructions. stallation and connection – Using the PowerUnit solo”). -
Page 28: Hardfloor Care Soft Roller (Hx Hc)
Using the supplied accessories Hardfloor Care soft roller (HX HC) (depending on model) Follow the flooring manufacturer’s cleaning and care instructions. Unlock the cover on the side of the Electrobrush so that the symbol becomes visible a. Lift the cover up as far as it will go b. ... -
Page 29: Electro Compact Handheld Brush (Hx Seb)
Using the supplied accessories Tip: If you ever need to vacuum up sub- Electro Compact handheld stantial amounts of coarse dirt or brush (HX SEB) debris, use the PowerUnit solo (see “In- (depending on model) stallation and connection – Using the PowerUnit solo”). Follow the flooring manufacturer’s cleaning and care instructions. -
Page 30: Battery Charger Cradle (Hx Ls)
Using the supplied accessories Battery charger cradle (HX LS) If you place the run-down battery in the charger cradle straight after use, it (depending on model) will only start charging once the bat- tery has cooled down. Before charging for the first time, you The cooling process can take up to must read the information in “Installa- 60 minutes. -
Page 31: Use
Switching on and off Selecting the suction power level Pull the plug out of the charging socket on the bottom of the battery. The suction power level can be adjus- ted for the specific situation. Reducing If you have been keeping the battery the suction power reduces the amount in the wall bracket, take the vacuum of effort required to manoeuvre the... -
Page 32: Self-Standing Function For Short Pauses In Vacuuming
Self-standing function for short pauses in vacuuming (For safety reasons, this function can only be used when the PowerUnit is fit- ted at the bottom of the vacuum cleaner) If you are vacuuming with the PowerUnit fitted at the bottom of the vacuum cleaner, you can easily inter- rupt operation while the appliance is switched on. -
Page 33: Maintenance
Risk of injury caused by rotating roller brush. Original Miele accessories are available You can injure yourself on the rotat- from the Miele webshop, the Miele Cus- ing roller brush. tomer Service Department and from your Miele dealer. Switch the vacuum cleaner off before doing any maintenance work. -
Page 34: Filter System
Maintenance Filter system Activating the ComfortClean function Always run the interim cleaning function for the fine dust filter before emptying the dust container. You should also run it whenever the suction power begins to drop. This enables the vacuum cleaner to achieve the very best cleaning perform- ance again straight away. -
Page 35: Emptying The Dust Container
Maintenance Emptying the dust container Provided that no prohibited sub- stances are present, the contents of Empty the dust container at the latest the dust container can be disposed of when the dust has reached the MAX with normal household waste. marking on the dust container. -
Page 36: Cleaning The Pre-Filter And Fine Dust Filter
Maintenance If chunks of dust, hair or coarse debris do not fall out, remove the pre-filter by pulling it upwards (see “Cleaning the pre-filter and fine dust filter” below). Turn the lid of the dust container back to its original position. ... - Page 37 Maintenance Risk of damage caused by incor- rect cleaning. The pre-filter can become damaged and be less effective as a result. Do not clean the pre-filter with water. Do not use pointed or sharp-edged objects to clean the filter. ...
-
Page 38: Cleaning The Dust Container
Maintenance Cleaning the Electrobrush/ handheld brush (depending on model) To do this, line up the guides (arrows) and turn the pre-filter back to its ori- ginal position. Close the dust container flap, making Disconnect the Electrobrush/hand- sure it clicks into place. held brush from the vacuum cleaner. -
Page 39: Replacing The Rechargeable Battery
Replacing the rechargeable brush). To remove them, use a flat- battery head screwdriver. An original Miele AP01/AP02/AP03 lith- Removing the roller brush from ium-ion rechargeable battery (HX LA) is the Electrobrush required. (Not possible with the handheld brush) -
Page 40: Error Messages
Bottom and middle in- “Battery overheating” or “Battery not recognised” er- dicators are flashing quickly Wait for approximately 30 minutes before switch- ing the vacuum cleaner back on again. Insert an original Miele AP01/AP02/AP03 lithium- ion rechargeable battery (HX LA). -
Page 41: Problem Solving Guide
(see “Installation and con- nection – General battery information” and “Char- ging the battery”). An original Miele battery has not been inserted. Insert an original Miele AP01/AP02/AP03 lithium- ion rechargeable battery (HX LA). The battery was not placed in the PowerUnit when charging it for the first time. - Page 42 Problem solving guide Problem Cause and remedy The Electrobrush The Electrobrush is overloaded – this can happen on switches itself off. surfaces like deep-pile carpet. Switch the vacuum cleaner off and switch it on again at a reduced suction power level. Use the On/Off switch on the Comfort handle to do this.
-
Page 43: Service
Warranty For information on the appliance war- ranty specific to your country, please contact Miele. See end of this docu- ment for address. In the UK, your appliance warranty is valid for 2 years from the date of pur- chase. -
Page 44: Cleaning And Care
Cleaning and care Risk of injury caused by rotating roller brush. You can injure yourself on the rotat- ing roller brush. Always switch the vacuum cleaner off before cleaning it. Use the On/Off switch on the Comfort handle to do this. -
Page 45: Optional Accessories
For intensive cleaning of car seats and carpeted stairs. Purchasing accessories Hardfloor Care soft roller Original Miele accessories are available from the Miele webshop, the Miele Cus- (HX HC) tomer Service Department and from For cleaning delicate hard floors. your Miele dealer. Radiator brush (SHB 30) Original Miele accessories are identified by the “ORIGINAL Miele”... - Page 46 Optional accessories AP01/AP02/AP03 additional battery (HX LA) For doubling the amount of time the va- cuum cleaner can be used for. Before charging for the first time, you must read the information in “Installa- tion and connection – General battery information”.
-
Page 47: Electrical Connection For The Uk
Electrical connection for the UK All electrical work should be carried out by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). The voltage and fre- quency are given on the data plate loc- ated underneath the vacuum cleaner. - Page 48 United Kingdom Miele Co. Ltd., Fairacres, Marcham Road, Abingdon, Oxon, OX14 1TW Tel: 0330 160 6600, Internet: www.miele.co.uk/service, E-mail: info@miele.co.uk Australia Ireland South Africa Miele Australia Pty. Ltd. Miele Ireland Ltd. Miele (Pty) Ltd. ACN 005 635 398 2024 Bianconi Avenue...