For connecting with a monitor TV that uses a 21 pin
connector for input (for Europe and U.K. models)
Make a connection as figured below with a commercially
available scart-plug connector cable.
Monitor TV
CONNECTING SPEAKER SYSTEMS
of the proper gauge, cut as short as possible. If the connections
are faulty, no sound will be heard from the speakers. Make sure
that the polarity of the speaker wires is correct, that is, + and –
markings are observed. If these wires are reversed, the sound will
be unnatural and will lack bass. Do not let the bare speaker wires
touch each other or any other metal part as this could damage this
unit and/or speakers.
NOTE: Use speakers with the specified impedance shown on the
IN
IN
rear of this unit.
VCR 2
VCR 2
OUT
OUT
MONITOR
MONITOR
OUT
OUT
No connection
PAL NTSC
Scart-plug
connector
NOTE: Banana Plug connections are also possible (Australia and
cable
General models only). Simply insert the Banana Plug connector
into the corresponding terminal.
Connect the SPEAKERS terminals to your speakers with wire
Red: positive (+)
Black: negative (–)
2
Unscrew the knob.
1
Insert the bare wire.
[Remove approx. 5mm (1/4")
insulation from the speaker
3
wires.]
Tighten the knob and
secure the wire.
25