GRE swim & fun HPGIC Instructions For Installation And Use Manual page 50

2.4.4 Choosing an operating mode
The operating mode can be adjusted depending the heating/cooling need for the pool, see "2.2.1 Mode details" for
more details about operating modes. To change the operating mode :
• Unlock the keypad: the main menu is displayed.
• Press to change the operating mode.
The different operating modes appear in the following order:
2.4.5 Adjusting the temperature setpoint
• Unlock the keypad : the main menu is displayed.
• Press and
• Press to confirm.
• When the setpoint temperature is exceeded by 1°C, the heat pump stops heating/cooling the water.
Then, the heat pump automatically regulates the pool water temperature (independant to the chosen
mode).
• The heat pump runs again to reach out the setpoint when there is a gap of 1°C between the pool water
temperature and the setpoint water temperature.
• Example: the setpoint temperature is 25°C and the pool water temperature has reached 26°C in heating
or cooling mode. The heat pump stops.
- In cooling mode, the appliance will automatically run again if the pool water temperature is higher
than 26°C.
- In heating mode, the appliance will automatically run again if the pool water temperature is lower
than 24°C.
• If heating priority is not activated, the heat pump waits for the next filtration pump cycle to run.
16
to set and modify the temperature setpoint, press SET to confirm the value.