Table of Contents
Advertisement
Available languages
Available languages
2.3.3 Antifreeze protection (if heating priority is activated)
• For the antifreeze protection to work, the heat pump must be powered and the filtration pump
activated. If the heating priority is activated, the antifreeze protection will work automatically.
When the heat pump is on stand-by, the system monitors the ambient temperature and the water temperature in
order to activate the antifreeze programme if required. The antifreeze protection is automatically activated when the
air temperature or water temperature are less than 2°C and when the heat pump has been shut down for more than
120 minutes. When the antifreeze protection is running, the appliance activates its compressor and the filtration pump
to reheat the water until it exceeds 2°C .The heat pump automatically leaves the antifreeze mode when the ambient
temperature is higher than or equal to 2°C or when the heat pump is activated by the user.
2.4 I User functions
2.4.1 Locking/unlocking the keypad
• Press
for 5
seconds to unlock the keypad. The keypad is automatically locked after 60 seconds of inactivity.
2.4.2 Setting the time (clock)
• Unlock the keypad: the main menu is displayed.
• Press
5 seconds to enter the clock setting interface.
• Press
-
the hours are
• Press
-
the minutes are
• Press
to confirm and return to the main screen.
2.4.3 Setting the timer
• If two different timers are set up on the filtration pump and on the heat pump, the timer on the
filtration pump will be ignored.
• If a timer is set on the heat pump, it is recommended to activate the "heating priority" to
ensure that the pool will be heated during this time slot (the heat pump only works when the
filtration pump is also working).
Three timer programs can be set up on the heat pump.
• Unlock the keypad: the main menu is displayed.
• Press
to enter Timer 1 functions. Timer 1 is blinking.
• Press
to enter Timer 1 ON
• Press
again
to set the minutes.
• Press
again to set Timer 1 OFF hours and minutes as done in the previous steps.
• Press
to confirm
Timer 1 ON/OFF settings.
• Press
and
to set Timer 2 ON/OFF
blinking. Press
and
blinking. Press
and
hours. Press
and
Press
and
settings.
to adjust the hours.
to adjust the minutes.
to adjust the start hours.
to adjust the start minutes.
EN
15
Advertisement
Chapters
Table of Contents
