Huawei NetCol5000-A035 Quick Manual page 14

Connecting the Power Cable and the (Optional) Signal Cable Between Indoor
8.2
and Outdoor Units
1. Outdoor units of different models have
different electric control box layout but
the same port silk screen.
2. The figure on the right shows the
bottom cabling mode. In top cabling
mode, you can route cables through the
holes shown in the figure.
3. The outdoor cables are sun- and water-
proofed. It is recommended that tubes
be used for protection.
4. The power and signal cables are routed
in accordance with the electric and ELV
cable routing specifications and the
cable routing plan.
5. The signal cable for the indoor and
outdoor units is mandatory when the
outdoor unit is equipped with an
intelligent temperature control
monitoring board.
(Optional) Connecting the Signal Cable Between Indoor and Outdoor Units
Perform this operation only for outdoor units configured with an intelligent monitoring board.
Connecting the Power Cables to the Outdoor Units
Power cable hole
(on the top)
Signal cable hole (on the top)
14