Table of Contents
Advertisement
I
NSTALLATION OF
Connect the hanger to the rear of the VX-177, with the notch pointing directly up,
using the supplied screw (Figure 1). Use only the screw included with the clip to
mount the clip to the back of the VX-177.
Clip the Quick-Draw Belt Clip onto your belt (Figure 2).
To install the VX-177 into the Quick-Draw Belt Clip, align the hanger with the Quick-
Draw Belt Clip, and slide the VX-177 into its slot until a click is heard (Figure 3).
To remove the VX-177 from the Quick-Draw Belt Clip, rotate the VX-177 180 de-
grees, then slide the VX-177 out from the Quick-Draw Belt Clip (Figure 4).
Figure 1
I
The optional FBA-25A Battery Case allows operation of the VX-177 using six "AA" size
Alkaline batteries.
When installing batteries, insert the (–) end first, then press in the (+) end so the battery
snaps into place. Always replace all six batteries at the same time, paying attention to the
polarity indicated inside the case.
The FBA-25A must not be used with rechargeable cells. The FBA-25A does not contain
the thermal and over-current protection circuits (provided in the "FNB" series of Ni-MH
Battery Packs) required when utilizing Ni-Cd and Ni-MH cells.
Note that the power output and battery life will be much shorter when using Alkaline AA
cells. They should be considered an emergency backup power source only, for this reason.
10
A
CCESSORIES
B
C
I
Figure 2
FBA-25A A
Figure 3
B
C
VX-177 O
Figure 4
O
M
Hide quick links:
Advertisement
Table of Contents
