1. Manuals
  2. Brands
  3. Trotec Manuals
  4. Dehumidifier
  5. TTR 12000
  6. Original instructions manual

Trotec TTR 12000 Original Instructions Manual

Desiccant dehumidifier
Hide thumbs Also See for TTR 12000:
Table of Contents

Advertisement

Quick Links

Download this manual
TTR 10000 / TTR 12000 / TTR 13500
EN
ORIGINAL INSTRUCTIONS
DESICCANT DEHUMIDIFIER

Advertisement

Table of Contents
loading

Related Manuals for Trotec TTR 12000

Summary of Contents for Trotec TTR 12000

  • Page 1 TTR 10000 / TTR 12000 / TTR 13500 ORIGINAL INSTRUCTIONS DESICCANT DEHUMIDIFIER...

  • Page 2: Table Of Contents

    This signal word indicates important information (e.g. material damage), but does not indicate hazards. Info Information marked with this symbol helps you to carry out your tasks quickly and safely. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 3: Safety

    • Before carrying out maintenance, care or repair work on the device, remove the mains plug from the mains socket. Hold onto the mains plug while doing so. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 4 The device is not a toy and does not belong in the hands of children. Warning Risk of suffocation! Do not leave the packaging lying around. Children may use it as a dangerous toy. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 5: Information About The Device

    In doing so, the contained moisture is withdrawn by the sorbent (silica gel) and retained (desiccation). Due to physical processes the temperature of the dry air (6) increases. Later the dried air flows towards the dry air outlet. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 6 Hence, additional throttle valves in the air lines are rendered redundant. Process air inlet Regeneration air inlet Dry air outlet Heater battery Humid air outlet (regeneration air) desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 7 If a safety component is tripped, the device will be switched off (STOP), but the overrun will remain active. Wait until the entire rundown period has lapsed before accessing internal parts of the device. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 8 Ventilation mode for outdoor installation • The air transport line for the dry air outlet (11) is led into the room to be dehumidified in order to feed dry air into ΔP excess pressure desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 9 Regeneration air inlet with connection for an air Regeneration air volume /h] / [Pa] transport line Weight [kg] Control box ventilation system incl. air filter(s) – Version Cable inlet for control lines Serial number – desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 10: Transport And Installation

    Prior to installation and switching the device on, check whether all air filters are inserted. Information regarding the air filter installation and filter change can be found in the Maintenance chapter. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 11: Assembly And Installation

    4. Remove the electrical control box cover either by pulling it forwards or by lifting it. Designation Process air inlet Regeneration air inlet Humid air outlet (regeneration air) Dry air outlet desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 12 1. Set the main switch to 0. 2. Loosen the screws and open the cover. ð The cover can only be opened if the main switch is set precisely to the 0 position! desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 13 These remote signalling contacts correlate with the lamps on the control panel (see description in the Operation chapter). For the correct assignment observe the wiring diagrams in the technical annex. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 14: Start-Up

    For adjustment work, measurements or the like, which have to be carried out during operation, one must on principle switch over to manual operation (ON-SITE)! desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 15: Operation

    - motor fault of the fans regeneration air or process air contact has been activated, the BETRIEB / OPERATION - possibly collective fault messages of additional options lamp (39) will be illuminated – the device starts up. (see Technical annex) desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 16: Errors And Faults

    • Have the device checked once a year by an electrically skilled person at any rate. 3. Then press the STÖRUNG / FAULT – RESET button (38) to acknowledge the STB faults or the ΔP fault message. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 17 • Check drive motor for proper functioning, have it replaced if necessary. • Check toothed belt pulley for tight fit, fasten it if necessary. • incorrect rotor rotation direction • Correct rotational direction. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 18 If the fault cannot be rectified despite following the checklist above, please contact one of our subsidiaries or our headquarters. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 19: Maintenance

    Dirty filters impair the performance ability of the dehumidifier. A filter change is required at the latest when the filter change indicator FILTER on the control panel lights up. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 20 1. To do so, open the filter flap at the electrical control box. 2. If it is dirty, replace the filter. Then close the flap again until it snaps into place. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 21 Do not use a cleaning agents containing solvents to avoid damage to the surfaces and operating elements of the devices. Clean the surfaces and operating elements of the devices with a damp cloth and solvent-free cleaning agents only. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 22: Harmful Influences On Rotors

    Reduces the internal pore surface of the silica gel leading to a loss of performance. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 23: Disposal

    Should you be unable to dispose of the device properly, please 4. Dispose of these supplies separately according to the contact the manufacturer and instruct him to carry out the applicable regulations. disposal on your behalf. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 24: Options

    To be able to read the control module's display, first open the front cover of the device (see instructions): desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 25 Selection target value external = 1, internal = 2, control value external = 3 ACT.Moist Actual value humidity in [°Cdp] SetP.Int. Target value humidity in [°Cdp], can be modified SetP.Ext. Target value external humidity in [°Cdp], display only desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 26 10. Control valve regeneration heating screen (optional) 1Ext2Int3Pas Selection target value external = 1, internal = 2, control value external = 3 Set.RegValve External signal Out RegValve Output O6 PWM signal Control value for control valve regeneration heating desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 27 Abort unwanted changes using ESC. 5. Press the buttons + or - to go to the next changeable value. 6. Repeat the steps 2 to 4 until all values are set. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 28 Error and fault messages can be reset by pressing the reset button. 6. Set a jumper from X6.40 to X6.41. The modifications are completed. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 29 If an additional heating is used, the STB • Check setting at STB, adjust. is prompted, too. • Check regeneration air volume. If the fault cannot be rectified, please contact one of our subsidiaries or our headquarters. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 30 6. Use the buttons ▲ / ▼ to reduce or increase the set value as desired. 7. Finally press the "P" button to save the settings for the new target value. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 31 2. Unscrew the protective cap of the STB reset device "7B1". 3. The STB can now be reset with a pen or screwdriver. 4. Afterwards, screw the protective cap back on. desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 32 • control panel protection Note Suitable on-site roofing or similar shall be provided in order to protect the device from a high solar irradiation (overheating) and snow loads (penetration of snowmelt). desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...

  • Page 33: Technical Annex

    Technical annex desiccant dehumidifier TTR 10000 / TTR 12000 / TTR 13500...
  • Page 35 Trotec GmbH & Co. KG Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...

This manual is also suitable for:

Ttr 10000Ttr 13500

Table of Contents