Advertisement
Electric Inboard Steering Actuator
OPTION 1 – Single ignition source
17
IGNITION
SOURCE
OPTION 2 – Splice into an existing engine ignition wire
18
IGNITION
SOURCE
Application specific instructions
How you wire the ignition will depend on the number of engines and actuators.
See table 5.
No. of
engines
1
Connect the ignition-sensing wire to the
engine ignition.
2
The ignition-sensing wires must be connected in
such a way that an ignition-on signal is received
when either of the engine ignition switches are
on. Some boats may be wired to deliver such an
ignition signal, but you may require a Dual Ignition
Kit (HA1201) to combine the ignition from a pair
of engines into a single source. See figure 19.
Table 5.
EN
MOLEX PERMA-SEAL BUTT SPLICE
P/N 0191640014 OR EQUIVALENT
TWIST WIRES
TOGETHER
MOLEX PERMA-SEAL STEP DOWN BUTT
SPLICE P/N 0191640043 OR EQUIVALENT
No. of actuators
1
TO ACTUATOR
TO ACTUATOR
TO ENGINE
Connect both ignition-
sensing wires to the
engine ignition.
Connect the ignition-
sensing wire of each
actuator to the
corresponding engine
ignition.
2
25
Advertisement
