Advertisement
Electric Inboard Steering Actuator
4
Electronic helm installation
Find the installation diagram for your helm in the following pages.
Before beginning the installation, carefully unpack the helm from the box and
check that you have all the required hardware shown in the diagram.
NOTE
A mounting template for each helm type can be found in section 7. Make
sure you are using the correct template before drilling or cutting the dash.
WARNING!
The helm must be grounded to the negative bus or battery negative
with the supplied ground strap, as shown in each installation diagram.
The steering sensor may be damaged by static electricity discharge if
the ground strap is not installed.
Sport Plus Tilt helm EH1532/EH1535
4
NUT
TORQUE TO
150 IN-LBS
SHAFT KEY
(EH1532
ONLY)
LIGHTLY
GREASE
SHAFT
TILT
MECHANISM
EN
STEERING
WHEEL
TILT PLATE
GROUND STRAP
3X WASHER
LOWER
BEZEL
ENGAGE HOOKS
WITH TILT PLATE
DASH
3X LOCK NUT
UPPER BEZEL
SEALING PLUG
MUST BE INSTALLED
IN UNUSED PORT
ELECTRONIC HELM
9
Advertisement
