Advertisement
Description
Harness, EPS, H4, 6 PIN FCI , F-F
Table 4.
5.3.2 Installation
Install the network tees as shown in figure
Plug the harnesses in to the tees. The connectors are keyed so that they only
install in one way. Hand tighten the connections. Do not use tools. Use tie wraps or
other means to secure the harnesses to prevent strain on the connection.
NOTE
The actuator harness has two DeviceNet connectors, labeled CAN2
and CAN3. Be sure you are connecting the one marked CAN2.
Ensure that you have two – and only two – terminating resistors, one at each
end of the network backbone, as shown in figure
When installation is complete, use a permanent marker to draw a line across all
DeviceNet connections. If one of the connections become loose it will be
evident.
22
Micro-c DeviceNet harness
LENGTH, FT (m)
16
Electric Inboard Steering Actuator
1 (0.3)
3 (0.9)
6 (1.8)
9 (2.7)
12 (3.6)
16 (4.9)
20 (6.1)
30 (9.1)
.
.
15
PART No.
CM10001
CM10003
CM10006
CM10009
CM10012
CM10016
CM10020
CM10030
EN
Advertisement
