Xerox WNA-100 User Manual page 8

Wireless network adapter
Hide thumbs Also See for WNA-100:
Table of Contents

Advertisement

Power Connector
Only use the power adapter supplied with the Xerox Wireless Network Adapter.
Ethernet Port
Use the included Ethernet crossover cable to connect directly to your PC, and then your
Ethernet enabled product.
Default (Reset Button)
A quick press of the Reset button prints a configuration page.
To restore the adapter to factory default settings, press and hold the Reset button on the rear
panel for about 5 seconds until all of the LEDs turn off, then release the button. This is
especially useful if you forget the configuration password.
The following table provides the default settings:
Parameter
Setting
IP Address
169.254.111.111
Password
access
Xerox WNA-100 Wireless Network Adapter
1-5
Introduction

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WNA-100 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents