Siemens HN878G4 0 Series User Manual And Installation Instructions page 33

Table of Contents

Advertisement

In order to use the drying function, set the drying
function.
→ "Setting the drying process", Page 33
Setting the drying process
1.
Allow the appliance to cool down.
2.
Remove coarse dirt from the cooking compartment
and wipe away moisture from the cooking compart-
ment floor.
3.
Press
​ ⁠ .
4.
In the operating mode menu, press the drying oper-
ating mode.
23  Appliance door
To clean the appliance door thoroughly, you can disas-
semble the appliance door.
23.1 Removing the door cover
The stainless steel inlay in the door cover may discol-
our. Remove the door cover in order to clean it and the
stainless steel inlay, or to remove the door panes.
1.
Open the appliance door slightly.
2.
Press down on the left- and right-hand sides of the
door cover.
3.
Remove the door cover and carefully close the ap-
pliance door.
23.2 Removing the door panes
WARNING ‒ Risk of injury!
Scratched glass in the appliance door may develop
into a crack.
Do not use any harsh or abrasive cleaners or sharp
metal scrapers to clean the glass on the oven door,
as they may scratch the surface.
The hinges on the appliance door move when the door
is opened and closed, which could trap your fingers.
Keep your hands away from the hinges.
Components inside the appliance door may have sharp
edges.
Wear protective gloves.
Requirement: The door cover has been removed.
1.
Undo and remove the screws on the left and right of
the appliance door.
The duration is set to 10:00 min. and cannot be
changed.
5.
Press
​ ⁠ to start the drying function.
a The appliance starts to dry and the duration counts
down.
6.
Once the duration has elapsed:
A message appears in the display.
Press
​ ⁠ to silence the audible signal before
it is due to end.
Press
​ ⁠ to switch the appliance off.
2.
Place a folded-up tea towel in the appliance door.
3.
Close the appliance door.
4.
Pull the front pane up and out.
5.
Place the front pane down on a flat surface with the
door handle facing down.
6.
Press the intermediate pane against the appliance
with one hand while pushing the left- and right-hand
retainers
​ ⁠ upwards. Do not detach the retainers
7.
Remove the intermediate pane.
Appliance door en
​ ⁠ .
33

Advertisement

Table of Contents
loading

Table of Contents