Safety Information - Xerox Synergix 8855 Supplementary Manual

Safety Information

Your AccXES™ controller has been designed and tested to meet strict
safety requirements. These include safety agency examination, approval,
and compliance with established environmental standards.
Please read the following instructions carefully before operating the
controller and refer to them as needed to ensure the continued safe
operation of the product.
Follow all warnings and instructions marked on or supplied with the product.
Unplug the controller from the wall outlet before cleaning the exterior.
Always use materials specifically designated to clean the controller exterior.
Other materials may result in poor performance and could create a
hazardous situation.
Do not use aerosol cleaners. Follow the instructions in this operator manual
for the proper cleaning methods.
Never use supplies or cleaning materials for purposes other than those for
which they were intended. Keep all supplies and materials out of the reach
of children.
Do not use this product near water, wet locations, or outdoors.
This product is equipped with a three-wire, grounding-type plug (i.e., a plug
having a grounding pin). This plug will only fit into a grounding-type power
outlet. This is a safety feature. To avoid the risk of electric shock, contact
your electrician to replace the receptacle if you are unable to insert the plug
into the outlet.
Never use a ground adapter plug to connect the controller to a power source
that lacks a ground connection terminal.
This product should be operated from the type of power source indicated
on the marking label. If you are not sure of the type of power available,
consult your local power company.
XES Synergix 8855 Controller Setup Manual for Firmware 7.0
The power supply cord is the disconnect device for this equipment.
Make sure that the installation is near the socket outlet and is easily
accessible.
Do not allow anything to rest on the power cord. Do not locate the
controller where someone can step on the cord.
Slots and openings in the controller are provided for ventilation. To ensure
reliable operation of the controller and to protect it from overheating, these
openings should never be placed near a radiator or heat register. The
controller should not be placed in a built-in installation unless proper
ventilation is provided.
Never push objects of any kind into the openings of the controller as they may
touch dangerous voltage points or short out parts, resulting in a risk of fire or
electric shock.
Never spill liquid of any kind on the controller.
Never remove any covers or guards that require a tool for removal. There
are no operator serviceable areas within these covers.
Never attempt any maintenance function that is not specified in this operator
manual.
Unplug the controller from the power outlet and refer servicing to qualified
service personnel under the following conditions:
• When the power cord is damaged or frayed.
•
If liquid has been spilled into the product.
•
If the controller has been exposed to rain or water.
• If the controller is producing unusual noises or odors.
• If the cabinet has been damaged.
•
If you need additional safety information concerning the controller or
supplied materials, you may call Xerox Engineering Systems.
i