Preparing The Host Scsi Port; Ultra Scsi Port (Host); Enable Controller Scsi Port; Software Supported - Xerox Synergix 8855 Supplementary Manual

Preparing the Host SCSI Port

Ultra SCSI Port (Host)

To use this port your workstation must have a SCSI interface card and
appropriate software installed and operating.

Enable Controller SCSI Port

Use the Printer_Defaults>Ports menu of the Web PMT to set a device
number compatible with your workstation and to disable the termination. By
default, the host SCSI port bus termination is enabled.
Figure 6 – Typical Web PMT, Ports Setup Page
XES Synergix 8855 Controller Setup Manual for Firmware 7.0

Software Supported

•
ServeWare Version 2.42 or later.
• VGS (in Xerox 150 Emulation Mode)

Data Formats Supported

•
Xerox 150 Emulation
• Versatec Raw Raster
• VDS
•
VCGL

SCSI Cable Description

The SCSI cable must not exceed a maximum length of 9.75 feet (3 meters).
15