Preparing The Serial Port; The Host Serial Port; Enable Controller Serial Port; Software Supported - Xerox Synergix 8855 Supplementary Manual

XES Synergix 8855 Controller Setup Manual for Firmware 7.0

Preparing the Serial Port

The Host Serial Port

This port requires a null modem serial cable to be connected from the
controller host serial port to the workstation serial port. It is necessary to use
the appropriate software drivers or system commands to send jobs to the
controller.
The controller serial host interface port supports user-definable Baud Rate,
Flow Control, and Parity.

Enable Controller Serial Port

Use the Printer_Defaults> Ports menu of the Web PMT to select the Baud
Rate, Flow Control, and Parity to match those set at the workstation.
Figure 5 – Typical Web PMT page, showing the serial port setup

Software Supported

PC/WINDOWS 95 AND WINDOWS 98 PLATFORM:

•
HP RTL Print Driver
•
ADI Drivers for AutoCAD R13/14
• HDI Drivers for AutoCAD 2000 and 2000i
• PostScript PPD System Print Driver
• Document Submission Tool (part of AccXES Client Tools)

PC/WINDOWS NT 4.0 AND WINDOWS 2000 PLATFORMS:

•
HP RTL/HP-GL/2 Print Driver
•
ADI Drivers for AutoCAD R13/14
•
HDI Drivers for AutoCAD 2000 and 2000i
•
PostScript PPD System Print Driver
• Document Submission Tool (part of AccXES Client Tools)

UNIX PLATFORM:

Does not apply to the serial port.
12