Rear Suspension Preload Adjustment - Triumph Bonneville Bobber Owner's Manual

Rear Suspension Preload
Adjustment
Bonneville Speedmaster Only
The spring preload adjuster is located at
the top of the rear suspension unit and
is accessed by removing the rider's seat.
Rear adjuster settings are counted from
one, with position one being with the
adjuster turned fully clockwise. Position
one gives the minimum amount of
spring preload. There are seven adjuster
positions in total. Position seven gives
the maximum amount of spring preload.
A
ckeb
1. Rear suspension preload adjuster ring
A. Counterclockwise direction
B. Clockwise direction
To change the rear suspension spring
preload setting:
• Remove the
page 56.
• Insert the C-spanner (C-spanner
and handle
underside of the rider's seat) into
the slots of the adjuster ring.
1
B
rider's seat, see
attached to the
• Turn the
counterclockwise
direction A in the diagram) towards
the left hand side of the motorcycle
to increase spring preload.
• Turn the adjuster ring clockwise
(shown as
diagram) towards the right hand
side of the motorcycle to decrease
spring preload.
Rear Suspension Settings
Preload Loading Condition
Solo riding
Solo riding with accessories/
loading (not exceeding limits)
Rider and passenger
Rider and passenger with
accessories/loading (not
exceeding limits)
1
Position 1 is minimum (fully clockwise) and
position 7 is maximum (fully counterclockwise).
Note
This chart is only a guide. Setting
requirements may vary for rider weight
and personal preferences.
The motorcycle is delivered from the
factory with the preload adjuster set at
position one.
Maintenance
adjuster
(shown
direction B in
Rear Spring
1
Preload
1
3
7
7
ring
as
the
105