Table of Contents
Advertisement
Final check
No.
Check point
Connection of Water
1
Inlet/Outlet
2
Hydraulic pressure
3
Water pump capacity
Transmission line and power
4
source wiring
5
The power cord specifications
6
3Way Valve
7
2Way Valve
8
Air Vent
WARNING
!
Do not use an automatic air-vent, as flammable refrigerant may leak into the water circuit and
get released through an automatic valve into the building.
- Check if the shut-off valves should be assembled with
Water inlet and outlet pipe of the unit
- Check the location of the water inlet/outlet water pipe
- Check the pressure of supplying water by using
pressure gauge inside the unit (Monitoring screen).
- Pressure of Supplying water should be Under 3.0 bar
approximately
- To secure enough water flow rate, do not set water
pump capacity as Minimum.
- It can lead unexpected flow rate error CH14.
(Refer to 'Water Piping and Water Circuit Connection')
- Check if Transmission line and power source wiring are
separated from each other.
- If it is not, electronic noise may occur from the power
source.
- Check the power cord specifications
(Refer to 'Communication cable')
- Water should flow from Water outlet of the unit to
sanitary tank Water inlet when sanitary tank heating is
selected.
- To verify the flow direction, Make sure that the water
outlet temperature of the unit and water inlet
temperature of sanitary Water tank are similar
- Water should not flow into under floor loop in cooling
mode.
- To verify the flow direction, check temperature at the
water inlet of the under floor loop.
- If correctly wired, this temperatures should not drop
below 16 °C in cooling mode.
- Air-vent must be located highest level of Water pipe
system
- It should be installed at the point which is easy to
service.
- It takes some times to remove air in the water system if
air purge is not performed sufficiently it may occur CH14
error. (Refer to 'Water Charging')
ACCESSORIES INSTALLATION
Description
101
Advertisement
Table of Contents
