Snapper 355Z Series Operator's Manual page 37

ParkingBrakeAdjustment
If the unit creeps with the engine shut off and the parking
brake engaged,the parking brake will need to be adjusted.
1. Disengagethe PTO,stop the engine, engagethe parking
brake, and remove the key from the ignition.
2. Raisethe seat plate to gain accessto the parking brake
components.
3. Measurethe distancefrom the top of the brake spring
rod (C, Figure37) to the top of the lock nut (D) on both
sides of the unit. The measurement should be 1/2" (1,27
cm). If not, adjust the Iocknut to achieve the
measurement of 1/2" (1,27 cm).
4. Measurethe distance between the bottom of the brake
shaft weldment (G) and the top of the set collar (F). The
measurement should be 3/8" (0,95 cm). If not, position
the set collar until the measurement equals 3/8" (0,95
cm).
NOTE."If this procedure does not correct the problem see
your dealer.
Figure 37. Parking BrakeAdjustment
A, Brake Spring
B. First Measurement- 1/2" (1,27 cm)
C. Brake Spring Rod
D, Lock Nut
E. Second Measurement- 3/8" (0,95 cm)
F, Set Collar
G, Brake Shaft Weldment
f_
¢'D
tip
35