Table of Contents
Advertisement
S A F E T Y G U I D E L I N E S
• DO NOT TOUCH the fixture housing during operation.
•
Turn OFF the power and allow approximately 15 minutes for the fixture to cool down before
serving.
• DO NOT shake fixture, avoid brute force when installing and/or operating fixture.
• DO NOT operate fixture if the power cord is frayed, crimped, damaged and/or if any of the power
cord connectors are damaged and do not insert into the fixture securely with ease.
• NEVER force a power cord connector into the fixture. If the power cord or any of its connectors
are damaged, replace it immediately with a new one of similar power rating.
• DO NOT block any air ventilation slots. All fan and air inlets must remain clean and never
blocked. Allow approx. 6" (15cm) between fixture and a wall for proper cooling.
•
When installing fixture in a suspended environment, always use mounting hardware that is at
least M10 x 25 mm, and always install fixture with an appropriately rated safety cable.
•
Always disconnect fixture from main power source before performing any type of service and/or
cleaning procedure.
•
Only handle the power cord by the plug end, and never pull out the plug by tugging the wire
portion of the cord.
•
During the initial operation of this fixture, a light smoke or smell may emit from the interior of
the fixture. This is a normal process and is caused by excess paint in the interior of the casing
burning off from the heat associated with the lamp and will decrease gradually over time.
•
Consistent operational breaks will ensure fixture will function properly for many years.
•
In the event that the fixture needs to be returned for servicing, use only the original packaging
and materials to transport the fixture.
7
Advertisement
Table of Contents
