ADJ FL1300 User Manual page 11

I N S TA L L AT I O N I N S T R U C T I O N S
DO NOT INSTALL THE FIXTURE IF YOU ARE NOT QUALIFIED TO DO SO!
Fixture MUST be installed following all local, national, and country commercial electrical and con-
struction codes and regulations.
Before rigging/mounting a single fixture or multiple interconnected fixtures to any metal truss/struc-
ture or placing the fixture(s) on any surface, a professional equipment installer MUST be consulted
to determine if the metal truss/structure or surface is properly certified to safely hold the combined
weight of the fixture(s), clamps, cables, and accessories.
Maximum ambient operating temperature is 104°F. (40°C)
Fixture(s) should be installed in areas outside walking paths, seating areas, or away from areas
where unauthorized personnel might reach the fixture by hand.
NEVER stand directly below the fixture(s) when rigging, removing or servicing.
Overhead fixture installation must always be secured with a secondary safety attachment, such as
an appropriately rated safety cable that can hold 10 times the weight of the fixture. Allow approxi-
mately 15 minutes for the fixture to cool down before serving.
TO MAINTAIN IP RATING INTEGRITY, ALL UNUSED CONNECTION RUBBER CAPS
MUST BE SEALED.
11