Xerox Phaser 3400 Reference Manual page 15

Troubleshooting Printing Problems
Half of the page is blank
Check the page orientation setting in the application program.
I
Make sure that the paper size in the tray and the software paper-size settings match.
I
The printer may have run out of memory for that job:
I
Reduce the complexity of the print job.
I
Do not send the entire job to the printer at once. Print it in sections instead, such
I
as pages 1-5, pages 6-10, etc.
Reduce the print resolution, such as from 1200 dpi to 600 dpi.
I
Add additional memory.
I
The printer ejects blank pages
Make sure that the file doesn't contain unwanted blank pages.
I
The laser print cartridge may be defective or out of toner. Replace the laser print
I
cartridge with a new one.
If the laser print cartridge is new, the sealing tape may still be in the laser print
I
cartridge. Remove the laser print cartridge, pull out the sealing tape, and then
reinstall the cartridge.
The computer displays an error message
There may be a software problem. Save your work, reboot your computer, and
I
re-submit the print job.
If the message occurs again, write down the error and look it up on infoSMART:
I
www.xerox.com/officeprinting/infoSMART/
Paper is not fed into the printer
Make sure that the paper is loaded correctly by removing the paper tray and reloading
I
the paper; refer to the Phaser 3400 Personal Laser Printer User Guide for more
information.
If paper is above the fill line, remove the extra paper.
I
If printing on heavy paper or special media, only use the multi-purpose tray. Be sure
I
to use paper supported by the printer; refer to the Phaser 3400 Personal Laser Printer
User Guide for more information.
Printing is too slow
The job may be very complex. If possible, reduce the complexity of the page or adjust
I
the print-quality setting.
The computer may need more memory if jobs frequently contain complex images.
I
10 Phaser 3400 Personal Laser Printer