Xerox Phaser 340 Instructions

Emptying the waste tray

Hide thumbs Also See for Phaser 340:

Download this manual

Emptying the waste tray

Approximate time to complete: 3 minutes

The waste tray ﬁts inside the maintenance tray which is located behind the

front cover. You should empty the waste tray anytime you remove the

maintenance tray or when the front panel displays the following message:

Waste Tray Full

Open Front Cover

Open the front cover.

Caution

Some surfaces inside the printer may be hot. Be careful not to

touch the areas marked with this caution icon:

9101-22

Page 1 Emptying the waste tray Approximate time to complete: 3 minutes The waste tray ﬁts inside the maintenance tray which is located behind the front cover. You should empty the waste tray anytime you remove the maintenance tray or when the front panel displays the following message: Waste Tray Full Open Front Cover Open the front cover.
Page 2 When you open the front cover, the following message appears: Waste Tray Full Remove Maintenance Tray Grasp the maintenance tray by the front edge and lift up while sliding it out of the printer. 9101-53 Note Once the maintenance tray has been partially used, it will leak drum ﬂuid if tipped.
Page 3 Lift one corner of the waste tray handle to release it from the maintenance tray; remove the waste tray from the maintenance tray. Empty the contents of the waste tray by twisting it. Used ink is nontoxic; it can be treated as normal ofﬁce waste. Each time you remove the waste tray to empty waste ink, be sure to empty the waste tray completely before replacing it in the maintenance tray.
Page 4 Replace the maintenance tray in the printer. Note To prevent media jams at the media tray, be sure to push the maintenance tray into the printer until both sides latch in place. Close the front cover. Source: 070-9101-03 C4...