Advertisement
4.
Remove the two screws securing the front of the EMI shield. Tilt the
shield up and remove it.
5.
Locate the DRAM SIMM module connector J6.
6.
Insert a keyed DRAM SIMM in connector J6 (or in J7 if J6 is already
filled, or in J8 if J6 and J7 are already filled) (a), and tilt the module
upright until it locks in place (b). Repeat Step 6 to install additional
memory modules.
Note
Install memory modules in the order J6, J7 and then J8.
When properly inserted, a tab on each end of the connector slips into a
hole on each end of the memory module. Also, a pawl on each end of
the connector latches around each end of the memory module to lock
it in place.
Note
The SD/SDX image processor accepts both 4-Mbyte and
16-Mbyte SIMMs. A single 4-Mbyte SIMM can be mixed with
16-Mbyte SIMMs only if the 4-Mbyte SIMM is the last SIMM
installed. Install options:
J6
4 Mbyte
16 Mbyte
16 Mbyte
16 Mbyte
16 Mbyte
16 Mbyte
4-Mbyte RAM SIMM Installation — (4690F4M)
J7
J8
empty
empty
empty
empty
16 Mbyte
empty
16 Mbyte
16 Mbyte
4 Mbyte
empty
16 Mbyte
4 Mbyte
21
4
31113-13
Advertisement
