Advertisement
Phaser II SX/DX
(slide-in style image processor board)
1.
Turn the printer off. Do not unplug the printer; this preserves a
ground path to dissipate static charges. Disconnect the host interface
cables.
2.
Loosen the rear panel thumbscrews.
1
3.
If just the image processor board is installed, then slide the image
processor board out of the printer. If the printer is equipped with a
multiplexer, then slide both the image processor board and the
attached 3-port multiplexer out of the printer.
4.
Lay the image processor board (and the multiplexer, if attached) on a
flat, static-free surface.
5.
Locate the connectors labeled SIMM #1, #2, and #3 on the image
processor board. (For the Phaser II DX printer, a memory module is
already installed in connector SIMM #1.)
5
Note
Install memory modules in the order #1, then #2, and then #3.
4-Mbyte RAM SIMM Installation — (4690F4M)
15
2
31113-9
3
4
31113-10
Advertisement
