Advertisement
6.
Insert a memory module in connector SIMM #1 (or in SIMM #2 if
SIMM #1 is already filled) (a), and tilt the module upright until it locks
in place (b).
#3
#2
a
#1
b
J2
J1
6
When properly inserted, a tab on each end of the connector slips into a
hole on each end of the SIMM. Also, a pawl on each end of the
connector latches around each end of the SIMM to lock it in place.
7.
Repeat Step 6 to install an additional memory module.
8.
Reinstall the EMI shield and the top panel. Reconnect the host
interface cables. Turn on the printer and make a test print to ensure
that the printer functions correctly.
4-Mbyte RAM SIMM Installation — (4690F4M)
J3
19
a
b
31113-14
Advertisement
