1 . A n t e n n a C o n n e c t o r
2 . O N - O F F S w i t c h
3. Microphone Jack
4. Scrambied (SC) Ciear (CL) Switch
Figure 1. TX-716, TX-916 Header Assembiy
1. Place the Antenna on the Antenna Connector (Figure
1, Item 1) and rotate clockwise to lock it in place.
2. Be sure fresh batteries are installed in the transmitter.
Refer to the Battery Replacement Installation
section of this manual.
3. Connect the Microphone by inserting the Microphone
Cable Connector into the MIC Jack (Figure 1, Item 3)
and rotating clockwise to lock it in place.
4. Set the Scrambled/Clear switch (Figure 1, Item 4) to
2