Table of Contents
Advertisement
8. 34 pin twisted ribbon cable for floppy disk (ACB-2322D only).
2.0 HARDWARE INSTALLATION
2.1 Introduction
This section describes the steps necessary to install the ACB-232XD board into the
computer. First, the operating environment, unpacking procedure and board layout are
described. This section also describes the integration of the drive and controller into the
computer.
2.2 Environmental Requirements
The ACB-232XD will perform properly over the following range of conditions:
Temperature:
Humidity (Noncondensing):
Altitude (Feet):
MTBF (Hours):
2.3 Unpacking Procedure
The carrier is responsible for damage incurred during shipment. In case of damage, have
the carrier note the damage on both the delivery receipt and the freight bill, then notify your
freight company representative so that the necessary insurance claims can be initiated.
After opening the shipping container, use the packing slip to verify receipt of the individual
items listed on the slip. Retain the shipping container and packing material for possible
later reuse should return of the equipment to the factory or distributor be necessary.
CAUTION: The ACB-232XD like all electronic equipment, is static sensitive. Please take
the proper precautions when handling the board. Keep the board in its conductive
wrapping until it is ready to be configured and installed in your system.
2.4 ACB-2322D Board Layout
The ACB-2322D is shown in Figure 2-1. This figure shows the location of the controller
microcode, ACB-BIOS, jumpers and connectors. Note that Pin 1 of the connectors is
identified by a square solder pad on the solder side of the board. The dimensions of the
board are:
Width:
3.90 Inches
Length:
8.00 Inches
Height:
0.75 Inches
(http://www.franken-online.de/ymmv)
ACB-232XD User's Manual
Operating
0ø to 55øC (32ø to 131øF)
0% to 95%
Sea level to 10,000
80,000 at 55øC
Storage
-40ø to 75øC (-8ø to 167øF)
10% to 95%
Sea level to 20,000
Page 5 of 26
Advertisement
Table of Contents
