Honeywell Sensepoint XCD Technical Manual page 81

Sensepoint XCD Technical Manual
A.3 User Configurable Parameter List
Menu
Set Calibration Zero calibration level
Set Calibration Span calibration level
Select Sensor Type of sensor
Select Gas Type of gas
Set Range Measuring range
Configure Inhibit Inhibit current
Configure Inhibit Inhibit timeout
Set Password Password
Set Calibration Interval Calibration Interval
Set Alarms Alarm 1 level
Set Alarms Alarm 1 rising/falling option
Set Alarms Alarm 2 level
Set Alarms Alarm 2 rising/falling option
Set Relays Relay 1 type
Set Relays Relay 1 action
Set Relays Relay 2 type
Set Relays Relay 2 action
Set Relays Relay 3 type
Set Relays Relay 3 action
Relay Operation Relay on delay time
Relay Operation Relay off delay time
Relay Operation Relay latch option
Set Location Location tag
Set Temperature Unit Temperature unit
Set Deadband Deadband option
Item
Set zero calibration gas level
Set span calibration gas level
Type of sensor from the sensor list.
Available only for the flammable / IR sensors.
Type of gas from the sensor list.
Available only for the flammable / IR sensors.
Measuring range
Inhibit current
Inhibit timeout
Password required for entering the Configuration mode
Calibration Interval
Alarm 1 level
Alarm 1 rising/falling option
Alarm 2 level
Alarm 2 rising/falling option
Type of relay 1 (Alarm 1, Alarm 2, Fault, Inhibit)
Type of relay 1 action (deenergize, energize)
Type of relay 2 (Alarm 1, Alarm 2, Fault, Inhibit)
Type of relay 2 action (deenergize, energize)
Type of relay 3 (Alarm 1, Alarm 2, Fault, Inhibit)
Type of relay 3 action (deenergize, energize)
Relay on delay time
Relay off delay time
Relay latch option
Location tag
Temperature unit
Deadband is included in the measuring range or not
81
SPXCDHMANEN Issue 15
Description