Honeywell Sensepoint XCD Technical Manual page 17

Sensepoint XCD Technical Manual SPXCDHMANEN Issue 15
Diagram 5 Mounting arrangements
To mount the Sensepoint XCD transmitter to a Vertical or Horizontal pipe/structure, use the optional
Sensepoint XCD Mounting Kit and following procedure:
Fit the four spring washers, then the plain washers to the M8 x 80 mm SS316 bolts.
Pass the four bolts through the four mounting holes of the transmitter housing.
Note: If the Sensepoint XCD sunshade is to be used then fit the sunshade and the two locking bolts
and washers to the M8 x 80 bolts.
Place the transmitter housing against the mounting position and fit the two 'U' channel mounting
bars the other side of the pipe/structure.
Secure bolts to the threaded holes of the 'U' channel mounting bars.
Tighten the four bolts securely, (but do not over-tighten) until the transmitter housing cannot be moved
by hand on its mounting position.
Note: For further details of installation refer to chapter 16.
17