7. See Figure 6. Carefully set the assembly upright onto the
casters.
8. Assemble Handle (F) to the Collector Body with two Flange
Bolts-M8. Use the supplied 12 mm Wrench to tighten .
Figure 6
4
9. See Figure 7. Push Upper Bag Support ( I ) into welded
support notches inside Collector Body (A) as shown.
Figure 7
10. See Figure 8. Thread one Quick Release Bag Clamp (J)
through the hemmed opening in the bottom of Filter Bag (G)
Figure 8
11. See Figure 9. Place the Bag assembly over the Upper Bag
Support onto the top grooved rim on Collector Body.
12. Fasten the Quick Release Bag Clamp.
Figure 9
13. See Figure 10. Remove the backing from the Adhesive Foam
Strip (supplied) and place it onto the bottom grooved rim on
lower opening of the Collector Body.
Figure 10