PowerTec 70293 Instruction Sheet

INSTRUCTION SHEET
Cyclone Dust Collection System
QUESTION...
1•847•780•6120
Visit us on the web at powertecproducts.com
Put these instructions and the original sales invoice
in a safe, dry place for future reference.
The Cyclone Dust Collection System turns a shop vacuum into a
2-stage cyclone separator. The Cyclone Dust Collection System
causes a vortex action inside the bucket to collect debris before it
enters the vacuum, this helps prevent the loss of suction power.
IMPORTANT SAFETY INSTRUCTIONS
Always follow basic safety precautions including the following.
WARNING
For your own safety, read, understand and follow the owner's
manual and all labels on the tools and dust collector/vacuum
before using any tool or equipment.
WARNING
Some dust created by operation of power tool contains chemicals
known to the State of California to cause cancer, birth defects
or other reproductive harm. To reduce your exposure to these
chemicals, work in a well ventilated area and work with approved
safety equipment. Always wear OSHA/NIOSH approved, properly
fitting face mask or respirator when using such tools. .
WARNING
Do not attempt to operate tool until it is completely assembled
according to the instructions.
WARNING
Metal shavings or dust can set sawdust on fire. Collect wood
materials only. Do not collect metal shavings or dust with anything
that has metal in it. Disconnect dust collector system from any tool
before working on metals. Remove all traces of wood dust from
inside that tool's dust traps. Remove all traces of metal shavings
or dust before reconnecting the vacuum/dust collector.
IMPORTANT: To prevent static build-up, make sure the hose
is grounding. Always ensure the dust collection network is
properly grounded. If in doubt, contact an electrician.
SAVE ALL WARNINGS AND INSTRUCTIONS
FOR FUTURE REFERENCE
UNPACKING
Packaging Contents
Refer to Figure 1
Figure 1
G
D
A
DESCRIPTION
A
6 Gallon plastic bucket with four
assembled casters
B
12" two stage cyclone separator lid
C 2-1/2" ID Polypropylene Hose – the hoses
collapse and expand from 10"–38-3/4"
D 2-1/2" Elbow
E
Nominal 2-1/4" to 1-1/2" Reducer
F Nominal 4" to 2-1/4" Reducer
G
Nominal 2-1/4" to 2-1/2" Quick Coupler (the
2-1/2" ends have left hand screw threads and
screw into provided hoses
H 4-1/4" Hose Clamp
I
2-3/4" Hose Clamp
Instruction Sheet (not shown)
NOTE: Contact the customer service center if any of these parts
are missing.
NOTE: After unit is assembled dispose of all packaging material
in an environmentally safe way.
Model No. 70293
I H
F
B
E
C
QTY
1
1
2
1
1
1
3
1
1
1
20-0930