Striping Unknown Disks - Xerox DocuColor 8000 Software Installation Manual

18
Close the Computer Management window.
5.
The Image Disks File System is not Formatted message appears.
6.
Click .
OK
You have completed Disk Striping.
7.
•
If configuration recovery information is available, proceed to Restoring the
Configuration on page 34.
•
If there is no backup and the system configuration must be done manually,
proceed to Configuring the Spire CXP8000 Color Server for the First Time on
page 25.

Striping Unknown Disks

Perform the following procedures if you:
•
Have replaced an image disk (low-level format all disks)
•
Have low-level formatted one image disk (low-level format all disks)
Important: When you replace an image disk or a low-level formatted one
disk, you must low-level format all image disks before you perform the
Striping Unknown Disks procedure, see Appendix B, Formatting the External
Device on page 45.
Initializing the Disks
Position the mouse pointer in the Disk 1 area, right-click, and select
1.
.
Disk
In the Initialize Disk dialog box, verify that the three image disk check boxes
2.
are checked.
Click
3. OK.
Spire CXP8000 Color Server 1.0 Software Installation Guide
Initialize