Clarke DEVIL 7015 Operation & Maintenance Instructions Manual

Clarke DEVIL 7015 Operation & Maintenance Instructions Manual

Electric fan heater

Advertisement

Quick Links

Only suitable for well insulated areas and not designed
to be the primary heat source
15KW ELECTRIC FAN HEATER
MODEL NO: DEVIL 7015
PART NO: 6935456
OPERATION & MAINTENANCE
INSTRUCTIONS
ORIGINAL INSTRUCTIONS
DL1123 Rev 10

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DEVIL 7015 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Clarke DEVIL 7015

  • Page 1 Only suitable for well insulated areas and not designed to be the primary heat source 15KW ELECTRIC FAN HEATER MODEL NO: DEVIL 7015 PART NO: 6935456 OPERATION & MAINTENANCE INSTRUCTIONS ORIGINAL INSTRUCTIONS DL1123 Rev 10...
  • Page 2: Function And Operating Parameters

    INTRODUCTION Thank you for purchasing this CLARKE product. Before attempting to use this product, please read this manual thoroughly and follow the instructions carefully. In doing so you will ensure the safety of yourself and that of others around you, and you can look forward to your purchase giving you long and satisfactory service.
  • Page 3 THE FOLLOWING TABLE ADDRESSES THE INFORMATION REQUIREMENTS OF REG.2015/1188 Item Symbol Value Unit Heat output Measured seasonal space heating energy efficiency Nominal heat output Minimum heat output (indicative) Maximum continuous heat output Auxiliary electricity consumption At nominal heat output At minimum heat output In standby mode Type of heat input for electric storage local heaters only Manual heat charge control with integrated thermostat...
  • Page 4: Safety Symbols

    6. Check the heater for damage before use. DO NOT use if the heater tubes/ elements are damaged or broken. Any damage should be properly repaired or the part replaced. If in doubt, DO NOT use. Consult your local CLARKE dealer. Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
  • Page 5: Maintenance

    Cleaning and Maintenance. 3. Only recommended parts should be used. Unapproved parts may be dangerous and will invalidate the warranty. 4. DO NOT attempt to repair a damaged heater, contact the Clarke service department. POSITIONING WARNING: DO NOT USE THE HEATER NEAR FLAMMABLE MATERIAL, LIQUIDS, SOLIDS, GASSES OR COMPRESSED GAS CYLINDERS ETC.
  • Page 6: Service And Repairs

    OPERATION 1. This heater is intended for drying & warming of commercial/industrial buildings where adequate ventilation is provided. It is NOT for domestic use or for heating habitable areas. 2. The heater should NOT be used by children or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge.
  • Page 7: Electrical Connections

    If in any doubt, consult a qualified electrician. DO NOT attempt any electrical work yourself. SAFETY SYSTEMS THERMOSTATIC PROTECTION The Devil 7015 has a thermal cut out to prevent the unit from overheating. The thermal cutout may also operate if the heater is shut down without allowing to cool sufficiently. If...
  • Page 8: List Of Pack Contents

    LIST OF PACK CONTENTS 1 x Heater 1 x Axle c/w Circlip (2) 1 x R/H & 1 x L/H Support Frames 2 x Wheel 1 x Upper Handle 1 x Fixings Pack ASSEMBLY 1. Fit the right leg frame to the main body as shown.
  • Page 9: Operation

    4. Use the nuts and bolts supplied, to secure the handle to the leg frames as shown. OPERATION WARNING: DO NOT USE THIS HEATER IN SMALL ROOMS WHEN THEY ARE OCCUPIED BY PERSONS NOT CAPABLE OF LEAVING THE ROOM ON THEIR OWN, UNLESS CONSTANT SUPERVISION IS PROVIDED.
  • Page 10 4. Set the mode selector to one of the settings: Fan Only Low Heat Setting Medium Heat Setting High Heat Setting • The heater will take up to three minutes to reach optimum temperature. 5. Once the room reaches the required temperature, turn the thermostat control slowly counter-clockwise until the thermostat clicks, leave the control in this position.
  • Page 11: Specifications

    • Make sure that the heater grill is not blocked. • No other maintenance is required, should you discover any problem with the heater, return it to the Clarke service department for repair. SPECIFICATIONS Operating Voltage, Current and Frequency:...
  • Page 12: Troubleshooting

    Fuse blown or Replace if necessary and investigate although circuit breaker cause. If fuse blows plugged in trips. repeatedly, consult your Clarke dealer. with the No power at Insert the plug in a suitable socket switch and socket outlet thermostat switched on.
  • Page 13: Parts Diagram

    PARTS DIAGRAM Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...
  • Page 14: Parts List

    PARTS LIST Front Rings Securing Plate R Front Grille Heating Elements Motor Insulate Board Rear Grille Chassis Panel Rear Rings Temperature Retaining Clip Securing Plate L Temperature Retaining Clip Adjustable Screw After Cooling Sensor Spacer Retaining Plate Securing Plate Grommet Decoration Cap Control Panel Wheel...
  • Page 15 DECLARATION OF CONFORMITY - UKCA & CE Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com...

This manual is also suitable for:

6935456

Table of Contents