Elation KL PAR FC IP User Manual page 12

I N S TA L L AT I O N G U I D E L I N E S
CLAMP INSTALLATION
This device features an attachment point for an Omega bracket built into the mounting
bracket, as well as two safety cable attachment points located on the rear face of the
fixture on either side of the control panel (see the illustration below). When mounting the
fixture to a truss or any other suspended or overhead installation, secure an appropriately
rated clamp (not included) to the Omega bracket, then attach the Omega bracket to the
mounting yoke and secure it in place using the twist-lock fasteners on the Omega bracket.
Attach a separate SAFETY CABLE of the appropriate rating to at least one of the two
provided attachment points.
ALWAYS ATTACH A SAFETY CABLE WHENEVER INSTALLING THIS FIXTURE IN A
SUSPENDED ENVIRONMENT TO ENSURE THAT THE FIXTURE WILL NOT FALL IF
THE CLAMP FAILS.
RIGGING
Overhead rigging requires extensive experience, including but not limited to: calculating
working load limits, understanding the installation material being used, and periodic safety
inspection of all installation material and the fixture itself. If you lack these qualifications,
do not attempt to perform the installation yourself. Improper installation can result in bodily
injury.
Mounting
Clamp
Omega
Bracket
Safety
Cable
12