Xerox 4215 Installation Planning Manual page 38

Interface enablement
Print language selection
XEROX 4219/MRP AND 4215/MRP INSTALLATION PLANNING GUIDE
Flow control Allows you to set the communication protocol to one of the
following:
• XON/XOFF (default communication protocol)
• Robust XON/XOFF
• DTR
For Robust XON/XOFF the printer will send an XON every second
while waiting for data. Robust XON/XOFF is available only when
the printer interface is set for PostScript mode.
Baud rate Allows you to select the baud rate for the serial interface.
Data width Allows you to set the word length to one of the following:
• 7-bit
• 8-bit (default).
Parity Allows you to set the parity at to one of the following:
• None (default)
• Odd
• Even.
DTR Polarity If DTR is selected for flow control the DTR polarity can be set
either high or low.
Other I/O (Twinax or Coax) interface
Allows you to enable or disable the Twinax or Coax interface.
When it is disabled no jobs will be processed from the Twinax or
Coax interface.
Allows you to select the following settings:
• PS/PCL Sensing (default)
• PostScript mode (Standard)
• HP LaserJet emulation mode
• PostScript mode (Binary)
• Hexadecimal dump mode
• PostScript mode (Tagged binary).
Note:
N
must be enabled and set for PS/PCL sensing.
PREPARING THE INSTALLATION CHECKLISTS
For 4215/MRP and 4219/MRP the Other I/O interface
5-5