Hyundai TUCSON Owner's Manual page 270

6
DO-IT-YOURSELF MAINTENANCE
12
8. Install a new copper washer of the
oil filter drain plug by the side of
lower case and retighten by turning
it clockwise.
Tightening torque : 0.8~1.0 kgf.m
9. After mounting a new oil filter ele-
ment and new O-ring to upper cap,
install the upper cap to lower case
and retighten by turning it clock-
wise. Do not over-tighten.
Tightening torque : 2.3~2.5 kgf.m
NOTE:
Be careful not to be the element
upside down when mounting the
element.
10.Remove the engine oil level dip-
stick.
11.Refill the crankcase with the rec-
ommended engine oil. Refer to
the specification in chapter 9 for
engine oil capacity.
!
CAUTION:
Slowly pour the recommended oil
using by a funnel. Do not overfill
not to damage engine.
12.Start the engine and check to be
sure no oil is leaking from the
drain plug or oil filter.
13.Shut off the engine and recheck
the oil level.
NOTE:
o It is recommended that the en-
gine oil and filter should be
changed by an authorized
Hyundai dealer.
o Always dispose of used engine
oil in an environmentally accept-
able manner. It is suggested that
it be placed in a sealed con-
tainer and taken to a service
station for maybe reclaimation.
Do not pour the oil on the
ground or put it into the house-
hold trash.
!
WARNING:
Used motor oil may cause irritation
or cancer of the skin if left in contact
with the skin for prolonged periods
of time. Wash your hands thoroughly
with soap and warm water as soon
as possible after handling used oil.