Hyundai TUCSON Owner's Manual page 245

Hide thumbs Also See for TUCSON:
Table of Contents

Advertisement

solution. Be sure to rinse the surface
after washing to remove the solution.
Never allow the solution to dry on the
painted surfaces.
!
CAUTION:
OJB037800
o Water washing in the engine com-
partment including high pressure
water washing may cause the fail-
ure of electrical circuits located in
the engine compartment.
o Never allow water or other liquids
to come in contact with electrical/
electronic components inside the
vehicle as this may damage them.
CORROSION PREVENTION AND APPEARANCE CARE
CORROSION PREVENTION AND APPEARANCE CARE
E030B01A-AAT
Spot Cleaning
Don't use gasoline, strong solvents or
corrosive cleaning agents. These can
damage the finish of the car. To re-
move road tar, use turpentine on a
clean, soft cloth or commercially avail-
able bug and tar remover. Be gentle.
To remove dead insects or tree sap,
use warm water and mild soap or car-
washing solution. Soak the spot and
rub gently. If the paint has lost its
luster, use a commercial car-cleaning
polish.
E030C01A-AAT
Polishing and Waxing
Always wash and dry the car before
polishing or waxing or using a combi-
nation cleaner and wax. Use a good
quality commercial product and follow
the manufacturer's directions on the
container. Polish and wax the bright
trim pieces as well as the paint.
E030D01A-AAT
When to Wax Again
You should polish and wax the car
again when water no longer beads on
a clean surface but spreads out over a
larger area.
E030E01A-AAT
Maintaining Bumpers
Special precautions must be observed
to preserve the appearance of the
bumpers on your Hyundai. They are:
o Be careful not to spill battery elec-
trolyte or hydraulic brake fluid on the
bumpers. If you
do, wash it off
immediately with clean water.
o Be gentle when cleaning the bumper
surfaces. They are made of soft
plastic and the surface can be dam-
aged if mistreated. Do not use abra-
sive cleaners. Use warm water and
mild soap or car-washing solution.
o Do not expose the bumpers to high
temperatures. For example, if you
have your car repainted, do not
leave the bumpers on the car if the
car is going to be placed in a high-
temperature paint booth.
4
4
5
5

Advertisement

Table of Contents
loading

Table of Contents