Hyundai TUCSON Owner's Manual page 50

1
FEATURES OF YOUR HYUNDAI
38
o When using the vehicle's "ISOFIX"
system to install a child restraint
system in the rear seat, all unused
vehicle rear seat belt metal latch
plates or tabs must be latched
securely in their seat belt buckles
and the seat belt webbing must be
retracted behind the child restraint
to prevent the child from reaching
and taking hold of unretracted seat
belts. Unlatched metal latch plates
or tabs may allow the child to
reach the unretracted seat belts
which may result in strangulation
and a serious injury or death to the
child in the child restraint.
o Do not mount more than one child
restraint to a single tether or to a
child restraint lower anchorage
point. The improper increased load
may cause the anchorage points
or tether anchor to break, causing
serious injury or death.
o Attach the ISOFIX or ISOFIX-com-
patible child seat only to the ap-
propriate locations shown.
o Always follow the installation and
use instructions provided by the
manufacturer of the child restraint.
B180B03JM-GAT
Pre-tensioner Seat Belt
(If installed)
Your Hyundai vehicle is equipped with
driver's and front passenger's pre-
tensioner seat belts. The purpose of
the pre-tensioner is to make sure that
the seat belts fit tightly against the
occupant's body in certain frontal col-
lisions.
The pre-tensioner seat belts can be
activated with the airbags.
HXG229
When the vehicle stops suddenly, or if
the occupant tries to lean forward too
quickly, the seat belt retractor will lock
into position. In certain frontal colli-
sions, the pre-tensioner will activate
and pull the seat belt into tighter contact
against the occupant's body.
Driver's airbag
1
Passenger's
airbag
3
2
1LDE3100
The seat belt pre-tensioner system
consists mainly of the following compo-
nents.
Their locations are shown in the illus-
tration.
1. SRS airbag warning light
2. Retractor pre-tensioner assembly
3. SRS control module
!
WARNING:
To obtain maximum benefit from a
pre-tensioner seat belt:
1. The seat belt must be worn cor-
rectly.
2. The seat belt must be adjusted to
the correct position.