Advertisement
4.1.3 Removing the transportation locks
1.Loosen all bolts with an appropriate wrench until they turn freely.
2.Remove the transport safety bolts by turning them slightly.
3.Insert the plastic covers in the bag containing the user manual to the openings on the rear panel.
CAUTION:
product will be damaged.
Keep the transportation safety bolts in a safe place to reuse when the washing machine needs to be moved again
in the future.
Install the transport safety bolts in reverse order of the disassembly procedure.
Never move the product without the transportation safety bolts properly fixed in place!
4.1.4 Connecting water supply
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have
10 – 80 liters of water flowing from the fully open tap in one minute to have your machine run smoothly. Attach a
pressure reducing valve if water pressure is higher.
CAUTION:
laundry will get damaged or the product will switch to protection mode and will not operate.
CAUTION:
4.1.5 Connecting the drain hose to the drain
Attach the end of the drain hose directly to waste water drain, lavatory or bathtub.
CAUTION:
Moreover, there is risk of scalding due to high washing temperatures! In order to prevent such situations and
make sure that the machine performs water intake and discharge processes without any problem, fix the drain
hose securely.
• To prevent the waste water to go back into the machine again and to ensure easy drainage,
do not immerse the end of the hose into the waste water or do not insert it into the drain for more
than 15 cm. If it is too long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose must not be
pinched between the drain and the machine.
Remove the transportation safety bolts before operating the washing machine! Otherwise, the
Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry.
1
Tighten the nuts of the hose by hand. Never use a tool when
tightening the nuts.
2 When hose connection is completed, check whether there is
leak problems at the connection points by opening the taps
fully. If any leaks occur, turn off the tap and remove the nut.
Retighten the nut carefully after checking the seal. In order to
prevent the water leaks and resultant damages, keep the taps
closed when you do not use the product.
Your drain house will be flooded if the hose comes out of its housing during water discharge.
5
• Connect the drain hose to a minimum height of 40
cm and a maximum height of 100 cm.
• In case the drain hose is elevated after laying it on
the floor level or close to the ground (less than 40 cm
above the ground), water discharge becomes more
difficult and the laundry may come out excessively
wet. Therefore, follow the heights described in the
figure.
EN
Advertisement
