Advertisement
Complying Commission Delegated Regulation (EU) No 1061/2010
Supplier name or trademark
Model name
Rated capacity (kg)
Maximum spin speed (rpm)
Height (cm)
Width (cm)
Depth (cm)
Net weight (±4 kg.)
Single Water inlet /
Double Water inlet
• Available
Electrical input (V/Hz)
Total current (A)
Total power (W)
Main model code
Technical specifications may be changed without prior notice to improve the quality of the product.
4.1 Installation
Apply to the nearest authorised service agent for the installation of your product.
Preparation of the location and electrical, tap water and waste water installations at the place of
installation is under customer's responsibility.
Make sure that the water inlet and discharge hoses as well as the power cable are not folded,
pinched or crushed while pushing the product into its place after installation or cleaning
procedures.
Make sure that the installation and electrical connections of the product are performed by
authorised service. Manufacturer shall not be held liable for damages that may arise from
procedures carried out by unauthorised persons.
Prior to installation, visually check if the product has any defects on it. If so, do not have it installed.
Damaged products cause risks for your safety.
4.1.1 Appropriate installation location
Place the product on a hard and level floor. Do not put it onto a carpet with high pile or other
similar surfaces.
When the washing machine and dryer are placed on top of each other, their total weight –when
loaded– amounts to 180 kilograms. Place the product on a solid and flat floor that has sufficient
load carrying capacity!
Do not place the product on the power cable.
Do not install the product in the environments where the temperature falls below 0 ºC.
Leaving a gap at the sides of the machine is suggested to reduce vibration and noise
On a graduated floor, do not place the product next to the edge or on a platform.
Do not place heat sources such as Hobs, Irons, Ovens, etc. on the washing machine and do not
use them on the product.
4.1.2 Removing packaging reinforcement
Beko
WCV9648XSTM
WCV10648XSTW
9
1200
84
60
59
67
• / -
220-240 V~ / 50Hz
220-240 V~ / 50Hz
10
2000-2350
1311
Tilt the machine backwards to remove the packaging reinforcement.
Remove the packaging reinforcement by pulling the ribbon.
Do not make this operation alone by yourself.
4
EN
Beko
Beko
WCV10648XSTS
10
1200
1200
84
60
64
74
• / -
220-240 V~ / 50Hz
10
10
2000-2350
2000-2350
138
138
Beko
WCV10648XSTM
10
10
1200
84
84
60
60
64
64
74
74
• / -
• / -
220-240 V~ / 50Hz
10
2000-2350
138
Advertisement
