BKS ixalo release terminal Pro Installation And Operating Instructions Manual page 7

Event
Standby
Permanent yellow LED
Transponder update successful
1x green LED an 1x beep
Transponder data processing/programming
Yellow LED flashes rapidly
Transponder blocked
1x red LED and 2x beep
Connection problem to EBK Pro
Yellow LED off for 1 s each minute
The FGT Pro has an invalid time
Red LED (1 Hz flashing)
FGT Pro has not been assigned to a master key system
Yellow LED 3x every 10 s
The user transponder is held in front of the FGT Pro but
which is not yet assigned to a master key system
3x yellow LED
The FGT Pro was successfully assigned to a master key
system with the master card
5x green LED and beeping
The FGT Pro could not be assigned to a master key system
with the master card
5x red LED
Error
Yellow LED off for 1 s each minute
Yellow LED off 2x every minute
LED flashes red at the FGT Pro
Transponder detection problems at
the FGT Pro
The LED at the FGT Pro briefly flashes
yellow three times consecutively, or
the LED flashes yellow three times
after presenting a transponder
None of the LEDs on the FGT Pro
light up
Release terminal
1x
5x
Cause Remedy
The FGT Pro has no con- „ Check the bus connection between the
nection to the EBK Pro EBK Pro and the FGT Pro
The EBK Pro has no con- „ Check if the BKS KeyManager online service is active
nection to the database „ Check the network connection between the
EBK Pro and BKS KeyManager
The FGT Pro has an „ Check if the BKS KeyManager online service is active
invalid time „ Check the network connection between the
EBK Pro and BKS KeyManager
External faults, e.g, due „ Eliminate fault
to power supply unit
FGT Pro is not assigned „ Initialise FGT Pro by presenting the master card
to a master key system
There is no voltage to „ Check power supply
the FGT Pro
1x
1 Hz
3x
3x
5x
1x
2x
7