Starting Up And Temperature Regulation - AEG ARCTIS 60190-5 GS User Manual

The red temperature pilot-lamp (A) blinks when:
– the appliance has been started up but the storage temperature has not
yet been attained;
– the minimum storage temperature is no longer being maintained (fault);
– excessive amounts of fresh food are placed inside; or
Important note: if you operate the fast-freeze switch or adjust the tempe-
rature regulator, it may happen that your appliance's refrigeration motor
does not start immediately but only after some time. This does not mean
that your appliance has a fault.

Starting up and temperature regulation

Please clean the appliance interior and all accessories prior to starting the
appliance. Plug in the appliance at the mains supply.
• Turn the ON/OFF knob (E). The green lamp (D) comes on.
• Turn the temperature regulator (E) in the direction of „1".
• To reset the sound alarm push the botton (C) and the alarm light (A) blinks
until the reaching of the storage temperature .
• Operate the fast-freeze switch (C). The yellow pilot lamp (B) comes on by
pressing the switch (C) again .
• Only when the red lamp (A) has gone out should you reset the fast-free-
ze switch (C) the yellow light (B) goes out by pressing the switch (C) again.
Setting "0": Off.
Setting "1": Hightest temperature, (warmest setting).
Setting "4" (end-stop) : Lowest temperature, (coldest setting).
The exact setting should be chosen keeping in mind that the temperature
inside the appliance depends on:
- the quantity of food stored
- how often the door is opened
- ambient temperature
Important:
Regularly check on the red temperature pilot lamp (A) that the required sto-
rage temperature is being maintained.
64