Table of Contents
Advertisement
ENG
3.1
ICM placement instructions
a.
After unpacking, check the cabinet for any damage caused during transportation. In the event of
damage, please contact the forwarding company.
b.
Always ensure that your merchandiser is installed on a stable surface/floor and is properly
levelled. The cooler must be levelled through proper adjustment of the levelling feet in all
installations. It must be ensured that the cooler does not exhibit any inclination towards its front
side and/or its lateral sides, after adjustment. A slight inclination toward its back side will further
facilitate the good circulation of the fluid and support the door closing mechanism. The use of a
spirit level is highly advisable to check levelling. There is 1 adjustable foot and 1 stable foot in
Flex 35 Tall HC, Flex 45 HC, Flex 45 SZ HC, Flex 60 HC and Flex 60 SZ [R600a] and 4
adjustable feet in Bar 150 [R600a], Bar 250 HD [R600a] and Bar 250 SD [R600a]. Take the
necessary precautions if lifting is required during installation. Do not allow the access of
unauthorized individuals during the cooler installation.
c.
The merchandiser must stand upright for at least 1 hour after transportation and prior to start-up.
This provides sufficient time for the oil to run back to the compressor after transit and
installation.
d.
Allow a minimum gap of 100mm at the back.
e.
Do not place anything on top of the ICM.
Note: Relocation of the ICM inside the outlet
a.
Empty the ICM and unplug from mains supply.
b.
Fully extract the levelling feet.
c.
Move the unit to the desired location with the assistance of another person.
3.2
Connection to the mains supply
Connect the ICM to a 220-240 Volt power supply on a min 10 A fused & grounded
socket. Do not use extension cables.
3
Do not place the merchandiser:
in direct sunlight or near heat sources (radiators, stoves & other
heating equipment)
outdoors, without proper protection from rain, moisture and
other atmospheric elements
in climate conditions for which it is not certified
in extreme environmental conditions (i.e. extensive exposure to
saline humidity)
Do not connect the merchandiser to:
a non-grounded wall socket or power line
improper supply voltage and frequency
power supply that does not comply with the safety regulations of
the appliance or with current legislation on electrical installations
Advertisement
Table of Contents
