Laser Safety; Disconnect Device - Xerox DocuColor 1632 Safety Notes

S N
A F E T Y O T I C E S

Disconnect Device

Laser Safety

ii
• If any of the following conditions occur, immediately switch off
the power to the machine and disconnect the power cord from
the electrical outlet. Call an authorized Xerox service
representative to correct the problem.
– The machine emits unusual noises or odors.
– The power cord is damaged or frayed.
– A wall panel circuit breaker, fuse, or other safety device
has been tripped.
– Liquid is spilled into the press.
– The machine is exposed to water.
– Any part of the machine is damaged.
The power cable is the disconnect device for this equipment. It is
attached to the back of the machine as a plug-in device. To
remove all electrical power from the machine, disconnect the
power cable from the electrical outlet.
Use of controls, adjustments, or procedures other than those
specified in this documentation may result in a hazardous
exposure to laser radiation. This equipment complies with
international safety standards. With specific regard to laser safety,
the equipment complies with performance standards for laser
products set by government, national, and international agencies
as a Class 1 laser product. It does not emit hazardous light, as the
beam is totally enclosed during all phases of customer operation
and maintenance.