High Temperature Self-Cleaning - Beko BBIS13300XMPE User Manual

1. Add 350 cc of white vinegar (acidity of
the vinegar shall not exceed 6%) to the
water pool on the base of the oven.
2. Wait at least 30 minutes to allow the
vinegar to dissolve the lime residues at
ambient temperature.
3. Clean the water pool with a soft wet
cloth with a dry cloth.
Do not use cleaning agents con-
taining acids or chlorides to clean
the water pool on the base of the
oven. Do not clean the lime that
may form in the water pool on the
oven base by scraping. Otherwise,
the product base shall be dam-
aged.
In order to increase the efficiency of de-
scaling likely in the water pool, in addi-
tion to the descaling steps above, after
every 10 uses:
Select an operating function in which the
lower heater is active and operate the oven
at 100 °C for 2-3 minutes. Then, turn off
the oven and spray the inside of the oven
and grill cleaner recommended on the
website for the brand of your product into
the water pool on the floor of the oven and
leave for 5 minutes. After 5 minutes, wipe
the pool of water on the floor of the oven
with a damp microfiber cloth and dry it.

7.5 High temperature self-cleaning

The oven is equipped with a pyrolysis fea-
ture. The oven heats up to a temperature
of approximately 420-480 °C and burns
until the existing dirt turns to ash. A strong
smoke may be generated. Provide good
ventilation. High-temperature cleaning
should be performed after approximately
every 10 uses of the oven.
General warnings
Hot surfaces cause burns!
Do not touch the product during
self-cleaning and keep children
away from the product. Wait at
least 30 minutes before removing
the residue.
• Before using the pyrolysis function, re-
move all accessories, the telescopic
shelf and the side shelves (if any). If not
removed, the accessories and side wire
shelves will be damaged.
• If your product has a pyro proof access-
ory (resistant to high temperature self-
cleaning), you do not need to remove
these accessories from the oven.
Whether your accessories are pyro-proof
or not is specified in the accessories
section. If not specified, your accessor-
ies are not resistant to high temperat-
ures. It must be removed from the oven
before cleaning to avoid damage.
• Do not clean the door seal. The glass
fiber seal is very delicate and easily
damaged. If the door seal is damaged,
replace it with a new one from an au-
thorized service.
• Drain the water tank before selecting the
self cleaning function with high temper-
ature. As the interior of the oven will
reach higher temperatures during clean-
ing, high noise and damage to the in-
terior surface of the oven may occur if
water is supplied to the inside of the
oven.
To start the pyrolysis function:
1. Remove all accessories inside the oven.
In the models with wire shelves, re-
member to remove the wire shelf.
EN / 36