Emerson Rosemount 700XA Quick Start Manual page 4

Quick Start Guide
WARNING
POWER
A suitable APPROVED switch and fuse or a circuit breaker shall be provided to facilitate the
disconnection of mains power.
WARNING
VENTILATION
Use the GC in a well-ventilated area.
If you plan to place the GC in a sealed shelter, always vent the GC to atmosphere with
0.25 in (6.4 mm) tubing or larger. This will prevent the build up of H
WARNING
LEAK TESTING
All gas connections must be properly leak tested at installation.
WARNING
PRECAUTIONARY SIGNS
Failure to observe precautionary signs may result in injury or death to personnel or cause
damage to equipment.
Observe and comply with all precautionary signs posted on the GC.
WARNING
TOXIC VAPORS
Exit ports may discharge dangerous levels of toxic vapors.
Use proper protection and a suitable exhaust device.
WARNING
BURN HAZARD
Failure to observe this warning could cause an explosion or potentially hazardous situation,
which if not avoided, may cause personal injury or death. Some parts of the analyzer may be
heated to 248.0 °F (120 °C).
To prevent burns, do not touch any of the hot parts. All parts of an analyzer are always hot
unless it has been switched off and allowed to cool down.
Before fitting, removing, or performing any maintenance on the analyzer, make sure
that it has been switched off and allowed to cool for at least two hours.
When handling the analyzer, always use suitable protective gloves.
These precautions are particularly important when working at heights.
If burned, seek medical treatment immediately.
4
November 2023
and sample gas.
2
Emerson.com