Copying Onto Tabs - Xerox CopyCentre 232 Supplementary Manual

Tab creation

Hide thumbs Also See for CopyCentre 232:

Copying onto tabs

This chapter describes how to copy onto tab stock.

Setup

Refer to the Section 2, Setup on page 3 and:

Load the tab stock into the Bypass Tray, Tray 1 or Tray 2

Create your tab master pages

Program Inserts

Tab dividers are copied using the Insert feature. This feature enables different types

of stock to be automatically inserted into a set. Up to 40 inserts can be added per copy

set.

Note:

– If your original document contains printed tab dividers that you wish to copy,

– The Insert feature can only be used with 1-1 or 2-2 sided copying and is not

– The Cover feature can also be selected to create a finished document with

– If your original document has more than 70 pages or mixed output

From the Basic Copying

screen select either 1 - 1 sided

or 2 - 2 sided copying.

Select the paper tray that

contains the stock you want to

use for the body of the

document which should be in

either Trays 3 or 4.

Select the Job Assembly tab.

Xerox CopyCentre, WorkCentre, WorkCentre Pro 232/238/245/255/265/275 Tab Supplement

refer to Copying using Build Job on page 12.

available when Auto Paper is selected.

covers front and back and printed tab dividers.

requirements, you will need to use the Build Job feature. Select Job

Assembly > Build Job > On > Save. You will need to split your original

document into segments and program the Inserts feature for each segment.

Table of Contents